This is an end view of several installation methods. When the sub rail is shipped separately, the sub rail is attached to the center of the baluster, using concealed fasteners, and then attached to top rail. Care must be taken to insure that the sub rail is sealed on outside edges from water run off.

The sub rail may be ordered pre attached, and we can supply your balusters with a dowel screw inserted in to the lathe center at the top baluster (dia.3). When using this method, the bottom of the sub rail is pre drilled on the correct baluster spacing and the baluster is twisted into the hole, where by it is automatically registered in the correct position side to side and on the desired baluster spacing. The bottom of the baluster is attached with one corrosion resistant screw through the bottom rail, which has been pre drilled the same as the top rail. This method uses the lathe center, which is a center depression on each end of the baluster. It quickly aligns the balusters in there correct location. This is the best method for home owners who would like to install their own rail system with out hiring a contractor. In order to use this system, you would need to order your balusters with the dowel screw, and the separate drill kit.

Please call if you need help on this method. Please note that the above installation methods show attachment using corrosion resistant screws. We sell these screws separately, if you can not locate them locally.800-360-2119.